Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Gate Repair in North Hollywood, CA
Gate access control in North Hollywood fails most often in August, when the San Fernando Valley heat pocket pushes temperatures past 105°F and the electronics inside keypads, card readers, and phone-entry boards cook in direct sun. The housing stock here, mostly 1940s-1960s bungalows and 1960s-1970s apartment complexes with gates retrofitted during the 1980s and 1990s, means we see control boards wired into conduit that was never meant to carry modern low-voltage signal lines. If your keypad works at 7am and goes dead by 2pm, call (213) 577-1120. Most North Hollywood access-control repairs are diagnosed in one visit.
Why North Hollywood Homes Are Different
North Hollywood sits squarely in the San Fernando Valley’s heat pocket, where summer temperatures routinely hit 105-110°F, often 20 degrees hotter than coastal LA on the same afternoon. That heat is the defining gate-repair driver in this neighborhood. Automatic operators overheat and shut down seasonally. Tubular-steel and wrought-iron frames expand enough that a gate swinging freely at sunrise can bind against its post by late afternoon. UV intensity, combined with near-zero coastal moisture, breaks down paint, welds, and rubber seals faster than in Studio City or Burbank.
The housing stock compounds the problem. Most single-family homes in North Hollywood are post-WWII bungalows from the 1940s through 1960s. The apartment buildings, dense two-story complexes from the 1960s and 1970s, had driveway and pedestrian gates added during a 1980s-1990s security push. Those gates and their original swing or slide operators are now 30 to 40 years old, which places them well past typical service life. Hinge sockets rust out, posts settle, control boards corrode.
There is one more local condition worth naming. The 1994 Northridge earthquake epicenter sat roughly four miles west of North Hollywood. Lateral ground movement shifted concrete gate-post footings across the Valley floor. Experienced local techs know to check post plumb first on any mystery bind call, because a gate that presents as a motor or wheel problem often turns out to be a post that has not been truly vertical since January 17, 1994.
Our Main North Hollywood Services
Two services dominate the North Hollywood call log: gate repair on aging swing gates that bind in the heat, and gate motor or opener replacement on units that overheat and trip thermal protection in July and August. Here are the three North Hollywood pages covering each in full.
Gate Repair in North Hollywood
Gate repair calls in North Hollywood most often start as a bind in the afternoon, a gate that scrapes the driveway or stops mid-travel when the frame expands in the heat. We find bent hinge barrels, cracked post sockets, and track sections out of alignment. Every repair starts with a written price handed over before any work begins. Full detail lives on the Gate Repair in North Hollywood page, including what we check first on homes built before 1970.

Gate Installation in North Hollywood
New gate installation in North Hollywood usually means replacing a 30-to-40-year-old swing gate whose hinges have wallowed out the post or whose bottom rail has rusted through at the welds. The Valley heat and the UV load here make powder-coated tubular steel the most common material we quote, not because it is all we offer but because it survives the sun better than raw wrought iron. See Gate Installation in North Hollywood for what a full written scope includes and what it costs.

Gate Motor & Opener in North Hollywood
Gate motors here fail in seasonal waves. The first triple-digit days of summer bring a cluster of thermal-shutdown calls on older swing-arm and slide operators. We service nine automation brands, including Linear, DoorKing, Viking, and Ghost Controls, so we repair what is already on the property rather than talking you into a replacement. The Gate Motor & Opener in North Hollywood page covers common failure modes and brand-specific pricing.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterGate Access Control in North Hollywood

Gate access control in North Hollywood means keypads, card readers, phone-entry systems, and video intercoms wired into gates that were mostly retrofitted during the 1980s and 1990s security push. The electronics sit in full Valley sun year-round, which means circuit boards and keypad membranes degrade faster here than almost anywhere else in the metro. We service what is there and wire in new components cleanly, with every connection photographed and documented under Clause 4 of The Haven Standard. Full service detail is on our Gate Access Control page.
Keypad Entry
Signs you need it
Keys work only sometimes, the keypad backlight flickers, or codes stop registering altogether on hot afternoons.
What it costs in North Hollywood
Keypad replacement and programming in North Hollywood typically runs $340-$540 depending on the model and wiring condition.
How we do it
We pull the old keypad, check the low-voltage wiring for heat-damaged insulation, install the new unit, program the codes, and photograph the finished board before we leave.
Card Reader
Signs you need it
Cards read intermittently, the reader chirps but does not release the gate, or one reader on a two-reader system stops responding.
What it costs in North Hollywood
Card reader replacement typically runs $380-$560 in North Hollywood, with the higher end for readers wired into apartment-complex control panels.
How we do it
We open the housing, test the reader output at the control board, replace the reader or the damaged cable run, and re-register all cards before closing the housing back up.
Phone Entry
Signs you need it
The call rings but the gate does not open, the call goes to the wrong unit, or the speaker cuts in and out.
What it costs in North Hollywood
Phone entry repairs in North Hollywood start at $260 for a line-level fix and run to $640 for a full board replacement on apartment systems.
How we do it
We trace the phone line to the entry panel, identify whether the fault is on the board or the wiring side, replace only the failed component, and test every unit code before we consider the job done.
What Gate Access Control Costs in North Hollywood
| Item | Typical range in North Hollywood |
|---|---|
| Keypad replacement | $340-$540 |
| Card reader replacement | $380-$560 |
| Phone entry repair | $260-$640 |
Can you fix an access-control keypad the same day I call?
Yes. Most keypad and card-reader repairs in North Hollywood are same-day jobs. We carry brands at the ready and keep pickup-stocked for the common failures. Call (213) 577-1120 and a live person answers, 24 hours a day.
Do you need to replace the whole access system if one reader fails?
No. We test the failed reader against the control board and replace only what is actually dead. Most single-reader failures in North Hollywood are wiring or board-level, not system-wide. The written price covers the repair, not a forced upgrade.
Gate Parts & Welding in North Hollywood

The dry UV-drenched air here causes welds to corrode from the surface inward, especially on gates painted over original raw steel. We carry hinges, rollers, and stock steel locally, and every weld we make is photographed and documented before the torch gets lit. Full detail is on our Gate Parts & Welding page.
Hinge Replacement
Signs you need it
The gate sags at the latch side, scrapes the driveway, or the hinge barrel gaps open when you lift the leaf.
What it costs in North Hollywood
Hinge replacement in North Hollywood runs $190-$440 per hinge, including cutting out the old weld and grinding the post clean.
How we do it
We lift and shim the gate leaf, cut out the failed hinge, grind the post and gate rail to bare metal, weld in the new hinge, and photograph the completed weld from two angles.
Post Replacement
Signs you need it
The post leans, the gate binds partway through its swing, or the post base shows cracking around the concrete socket.
What it costs in North Hollywood
Post replacement in North Hollywood typically runs $520-$900 including the new post, concrete, and re-hanging the gate.
How we do it
We saw the old post off, break out the ruined footing, check the hole for the shifted soil common across the Valley floor since the Northridge quake, set a new post plumb and true, and re-hang the gate after the concrete cures.
What Gate Parts & Welding Costs in North Hollywood
| Item | Typical range in North Hollywood |
|---|---|
| Hinge replacement | $190-$440 per hinge |
| Post replacement | $520-$900 |
| Rail repair weld | $180-$420 |
Can you weld a gate back together or does the whole gate need replacing?
Most welds can be cut out and re-welded stronger than the original, especially on tubular-steel gates common in North Hollywood. We replace the whole gate only when the metal has rusted through in multiple places. The written price tells you which path applies before any work starts.
How long does a welded gate repair last?
A properly ground and welded repair on a clean steel surface lasts as long as the original weld, often longer. We photograph every weld. The 365-Day Done Right Promise covers the repair for a full year with no charge if it is not right.
Brands We Service in North Hollywood
We service Linear, DoorKing, Viking, and Ghost Controls operators in North Hollywood, along with five other major automation brands. We stock common control boards and remote transmitters locally, so most motor repairs in North Hollywood go from diagnosis to done in one visit. See our brands for the full list.
Pricing for Gate Repair in North Hollywood, CA

| Service | Typical range in North Hollywood |
|---|---|
| Gate realignment and limit switch adjustment | $180-$340 |
| Gate roller replacement | $220-$460 |
| Swing-gate motor replacement | $590-$980 |
| Slide-gate motor replacement | $640-$1,080 |
| Hinge replacement | $190-$440 per hinge |
| Post replacement | $520-$900 |
| Keypad replacement | $340-$540 |
| Card reader replacement | $380-$560 |
| Phone entry repair | $260-$640 |
| Rail repair weld | $180-$420 |
North Hollywood heat pushes labor and material costs up in the summer months, and post-1994 quake footing shifts sometimes add concrete work to a job that looked like a simple motor fix from the street. Whatever the price, it is written down and handed to you before we start, under Clause 1 of The Haven Standard. No surprise invoices, no verbal estimates that change at the end.
Neighborhoods We Serve in North Hollywood
We work across North Hollywood, including the older bungalow courts and the apartment-heavy blocks east of Lankershim. Typical response for a gate repair call in North Hollywood is same day or next morning. The crews already know the streets and the common gate types on them, which cuts diagnosis time.
- NoHo Arts District
- Toluca Woods
- Valley Glen
- West Toluca Lake
- Amelia Earhart area
Service Area - Cities Near North Hollywood

Our North Hollywood crews also cover the neighboring cities where the gate stock is similar but the conditions shift slightly. Studio City, CA, Van Nuys, CA, Sun Valley, CA, and Burbank, CA all sit close enough that response times stay short and the written-price policy stays the same.
Serving North Hollywood, CA - Our Local Coverage Area
We’re based in the North Hollywood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in North Hollywood

Usually same day. Live dispatch operates around the clock, so a call at any hour reaches a person who can send a technician. Most North Hollywood gate failures, motor shutdowns and broken hinges, get a same-day or next-morning visit. Call (213) 577-1120 for the current schedule.
Most repairs and parts replacements require no permit. A full automatic gate installation may, depending on the city’s current rules and the gate’s location. We handle the paperwork side and tell you in the written scope whether a permit applies to your job.
Yes, and it is the number one seasonal driver here. Metal frames expand in 105°F heat and bind against posts, motors trip thermal protection, and UV beats down control boards. Coastal neighborhoods rarely see these failures, but in North Hollywood they are routine every July through September.
Call (213) 577-1120 for a free, written estimate on any gate repair in North Hollywood. The price is in your hand before any work starts.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What North Hollywood Customers Say
"Quoted in writing, installed on the day promised, and the price did not move. The crew was licensed and the number was on the paperwork."
- Wes A."Good work on a long driveway gate. Arrived when they said, finished when they said."
- Sofia E."Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B.





Before
After
Before
After