Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Tarzana, CA
Most of the calls we take for gates in Tarzana fall into two categories: an access-control system that no longer talks to its remote or keypad, or metalwork that has failed under heat and Santa Ana wind. The hillside estates south of Ventura Boulevard hold a concentration of 25-to-40-year-old automated gates whose original operators were sized for lighter aluminum panels than the ornamental iron they now swing. That mismatch shows up as burned-out motors, stripped drive gears, and intercom systems that work intermittently. If your gate is dead on its post or your keypad stopped accepting codes, call (213) 577-1120 and we’ll send a technician who writes the price down before any work begins.
Why Tarzana Homes Are Different
Tarzana’s housing stock splits sharply, and the split runs right along Ventura Boulevard. The flatlands north of it hold post-WWII ranch and tract homes where side-yard gates are usually simple chain-link or wood. South of the Boulevard, the streets climb, and the gates change with them: long driveways, dual-swing ornamental iron, buried operator loops, and access-control systems original to 1970s and 80s construction. Those hillside systems are now well past their rated service life.
The climate accelerates the failures. Tarzana regularly logs summer highs above 105°F, fifteen to twenty degrees hotter than coastal Los Angeles. That heat expands steel frames, warps wooden infill panels, and cooks the circuit boards and solenoids inside older DoorKing and Apollo operators. Then fall Santa Ana winds push sustained gusts through the hillside corridors, bending gate posts and snapping weld joints on heavier iron gates. Flatland gate companies rarely diagnose thermal expansion as a root cause. In Tarzana, we see it almost every week.
Our Main Tarzana Services
Two service categories dominate the calls we take from Tarzana homeowners. Below are the three specific Tarzana service pages with full pricing and job detail.
Gate Repair in Tarzana
A failed gate in Tarzana is usually one of three things: a burned operator from the heavy-iron-on-light-operator mismatch, a weld joint cracked by Santa Ana wind, or an access-control fault that didn’t survive a 105-degree summer. Gate Repair in Tarzana covers all three, with the written price handed over before our technician touches a tool.
Gate Installation in Tarzana
New gate work in Tarzana means sizing the operator to the actual gate weight, not the original 1980s specification. Hillside driveways add slope, drainage, and sometimes HOA review. Gate Installation in Tarzana walks through the full process, from post depth in decomposed granite soil to the final photo log.
Gate Motor & Opener in Tarzana
When the motor runs but the gate doesn’t move, or the gate moves a few inches and stops, the limit switch or the drive gear is usually at fault. Gate Motor & Opener in Tarzana covers diagnosis and replacement across the brands homeowners actually have on their posts: LiftMaster, FAAC, BFT, Linear, Viking, and DoorKing.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Tarzana
Gate access control in Tarzana is the system that decides who gets in: keypads, remotes, phone-entry boxes, card readers, and video intercoms. The hillside estates south of Ventura Boulevard frequently still have their original 1980s intercom and keypad hardware, now operating through decades of 105-degree summers that degrade circuit boards and corrode wire connections. Our Gate Access Control work covers diagnosis, repair, and replacement, always with a written price first and a photo record when we leave.
Keypad Entry
Signs you need it
The keypad accepts some codes but not others, or the buttons have worn to the point where the numbers are unreadable.
What it costs in Tarzana
Keypad replacement in Tarzana typically runs from $150 to $450 depending on whether the controller board is separate or integrated and whether new wire needs to be pulled through existing conduit.
How we do it
We trace the wire from the keypad to the control board, test voltage at both ends, then replace the keypad or the board and program the new codes in front of you, photographing the final settings.
Phone Entry
Signs you need it
Visitors press the call button and the handset inside the house never rings, or the line rings busy because the old unit never hung up.
What it costs in Tarzana
Phone-entry repair or replacement runs from $250 to $900 in Tarzana, with the high end reserved for systems that need a new cellular dialer rather than a landline connection.
How we do it
We test the relay, the dialer, and the power supply separately, then replace only the failed component rather than the entire box when the rest of the unit tests clean.
What Gate Access Control Costs in Tarzana
| Item | Typical range in Tarzana |
|---|---|
| Keypad replacement | $150 – $450 |
| Phone-entry repair | $250 – $900 |
| Video intercom replacement | $600 – $2,400 |
Can you replace just the keypad and keep my existing operator?
Yes, in most cases. The keypad connects to the operator’s open-command input, so as long as the operator board still works, a new keypad integrates directly. We test the operator’s open and close circuits before recommending any replacement.
Do you service phone-entry systems that use a landline when I only have VOIP now?
We do. Older phone-entry units often fail to hang up on VOIP lines because the line voltage is too low, so we install a small relay adapter or switch the unit to a cellular dialer. We explain which fix fits your phone service before quoting the written price.
Gate Parts & Welding in Tarzana
Gate parts and welding in Tarzana covers the metalwork that keeps a gate on its hinges and moving straight: hinge replacements, post resets, rail repair, and custom welding. The heat and wind work against every weld and every buried post on these hillside lots, and we find cracked welds at the mid-rail and hinge plates more often in this zip code than in the flatland cities to the north. Our Gate Parts & Welding work includes machining or sourcing the exact part, then welding and grinding it flat so the repair disappears into the original work.
Hinge Replacement
Signs you need it
The gate sags toward the latch side, the hinge pins show visible wear or rust, and the gate scrapes the driveway when it swings.
What it costs in Tarzana
Hinge replacement typically runs from $180 to $650 in Tarzana depending on whether it’s a light side-yard gate or an ornamental iron driveway gate that needs the gate un-weighted for the swap.
How we do it
We support the gate with a jack, cut and grind the old hinge from the post, align the new hinge to the gate’s existing mounting holes, weld it in place, and photograph the finished weld.
Post Replacement
Signs you need it
The gate post leans even when the gate is unweighted, or the concrete around the post base is cracked and the post rocks under hand pressure.
What it costs in Tarzana
Post replacement runs from $850 to $2,300 in Tarzana, with the high end covering hillside driveways where the old post must be cut out and the new one set in a deeper footing.
How we do it
We cut the old post at the base, dig a new footing below the original depth, set the post plumb in concrete, and return after the cure to re-hang the gate and set the limits.
What Gate Parts & Welding Costs in Tarzana
| Item | Typical range in Tarzana |
|---|---|
| Hinge replacement | $180 – $650 |
| Post replacement | $850 – $2,300 |
| Custom welding repair | $250 – $1,400 |
Can you weld ornamental iron so the repair is invisible?
Yes. We grind the weld flush, match the texture of the surrounding iron, and repaint the repaired section. On a black ornamental gate, the repair line is effectively undetectable at a normal viewing distance.
Do you set posts deeper than the original footing in Tarzana’s soil?
We set every replacement post below the original footing depth and add rebar when the driveway has a steep slope or the original post failed due to wind loading. Deeper footings hold better against Santa Ana gusts.
Brands We Service in Tarzana
Our Tarzana crews work on Linear, Viking, Ghost Controls, and DoorKing operators, alongside LiftMaster, FAAC, BFT, Mighty Mule, and Elite. We stock control boards and remotes for most of these brands locally, which means no two-week wait for a board. See our brands for the full picture.
Pricing for Gate Repair in Tarzana, CA
| Service | Typical range in Tarzana |
|---|---|
| Keypad replacement | $150 – $450 |
| Phone-entry repair | $250 – $900 |
| Video intercom replacement | $600 – $2,400 |
| Hinge replacement | $180 – $650 |
| Post replacement | $850 – $2,300 |
| Custom welding repair | $250 – $1,400 |
| Swing-gate motor replacement | $1,200 – $2,800 |
| Slide-gate motor replacement | $1,800 – $4,200 |
What pushes a Tarzana gate job to the high end is almost always access: a hillside driveway that requires hand-carrying tools and materials, a post set into decomposed granite that needs a deeper footing, or an operator that must be re-sized because the gate was upgraded to heavier iron without the motor. The written price we hand you before the job starts is the price you pay. No variable labor charges, no surprise invoice on the back end.
Neighborhoods We Serve in Tarzana
We work the flatlands and the hillsides, from ranch-house side gates to estate driveways all across the 91356 zip code. Our response time across Tarzana is typically same-day for diagnosis of a dead gate, and next-day for scheduled metalwork when parts need to be ordered.
- Melody Acres
- Tarzana Hills
- Wellswood
- Corbert Canyon
- Reseda Ranch
Service Area - Cities Near Tarzana
We also serve the surrounding San Fernando Valley cities along the 101 corridor. If you’re in Encino, CA, Reseda, CA, Sherman Oaks, CA, or Van Nuys, CA, the same written-price process and photo-record documentation apply. Dispatch is coordinated from our Los Angeles office, and crews route locally through the Valley every day.
Serving Tarzana, CA - Our Local Coverage Area
We’re based in the Tarzana area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Tarzana
For a gate that will not close or is stuck open, we can usually have a technician in Tarzana the same day. The diagnostic is done on site, the written price comes before any work starts, and many common failures are repaired in the first visit because we stock boards and remotes locally.
Repairs, hinge swaps, and operator replacements generally don’t require a city permit. New gate installations on hillside lots may require plan check if the gate is on a retaining structure or changes drainage. We review the property with you and tell you exactly what applies before you commit to anything.
Every visit ends with a written record of what we found, what we adjusted, and what part number we installed. You get a photo log of the final limits, wiring connections, and weld points. The same record stays on file so the next service call starts from evidence, not guesswork.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Tarzana Customers Say
"Honest about what did not need doing. Told me the operator had years left and only the control board needed replacing."
- Douglas N."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."Quoted in writing, installed on the day promised, and the price did not move. The crew was licensed and the number was on the paperwork."
- Wes A.